3-pin plugs and parts

General
1

Yay, yet another Charging Plug… was my First thought…

The Gouach Charger hast this 3pin Plug, that hasnt been Seen around before!? :roll_eyes:

But hej, now that ist here, could we please have parts available in the shop?
3pin Plugs to make adapters for solar charging or for existing CycleSatiators or other Chargers.

3 pin female parts to replace or for other appliances?

That would be appreciated :+1:t2:

2

Hello Eric,

yes understood.

Someone else from the community asked an adaptator from XLR to our plug (JL-F-Z3105AM)
Do you think we should:

  • sell bare wire JL-F-Z3105AM so that people weld waterever they need
  • sell JL-F-Z3105AM to XLR ?

Please note that you can charge from the discharge connector too, meaning that you can plug whatever connector on the power line and that would be equivalent to using a charger.
For solar bikes, it would even be recommended as you can put more current in the bigger wires of the discharge connector.

Best

3

Thanks for the part number. It looks like it has been used on other ebikes before :slight_smile:
I didnt succed when i tried to Charge the gouach Pack with the satiator through the powerpole cable that i connected to the batt holder.
The holder Switch was on.

4

hello Eric,

yes the Cycle satiator from grin is a bit special as it senses the voltage on line before starting to charge.
At the same time, when the button is off, the Infinite Battery works the same way on the discharge port: it senses to see if there is voltage, so you cna imagine a setup where they never “meet” and the charge never happens.

However I’m surprise that even if you have the battery turned on (we are speaking of the button on the support right ?) and that you try to charge from the satiator plugged to the support is doesn’t charge ? Do you confirm the setup ?

5

Hello Alex,
It would be nice to sell bare wire so that people weld waterever they need. The DC 5.5/2.1 or GX16 connector is also used in many bike and it ‘s easy to buy.

Also your (julet ?) connector seem compatible with the higo Z311A connector. Some sell adapters but there is often no indication of the pin wiring. Ecoride CHARGER ADAPTER CABLE - XLR female to z311 male - cable length 500mm

1 Like